Philips MZ1100 Instrukcja Użytkownika Pobierz pdf (Strona 7)

English

3139 115 21652

General Information

This system complies with the FCC

rules, Part 15 and with 21 CFR

1040.10. Operation is subject to the

following two conditions:

– This device may not cause harmful

interference, and

– This device must accept any interference

received, including interference that may

cause undesired operation.

Environmental information

All unnecessary packaging has been omitted.

We have tried to make the packaging easy to

separate into three materials: cardboard (box),

polystyrene foam (buffer) and polyethylene

(bags, protective foam sheet).

Your system consists of materials which can be

recycled and reused if disassembled by a

specialized company. Please observe the local

regulations regarding the disposal of packaging

materials, exhausted batteries and old equipment.

Maintenance

To clean a CD, wipe it in a straight line from the

centre toward the edge using a

soft, lint-free cloth.

A cleaning agent may damage the

disc! Write only on the printed

side of a disc and only with a soft

felt-tipped pen.

Clean the system with a soft,

slightly dampened, lint-free

cloth. Do not use any

cleaning agents as they may

have a corrosive effect.

Do not expose the system

batteries or discs to

humidity, rain, sand or

excessive heat (caused by

heating equipment or

direct sunlight).

Safety information

● Place the system on a flat, hard and stable

surface.

● Place the system in a location with adequate

ventilation to prevent internal heat build-up in

your system. Allow at least 10 cm (4 inches)

clearance from the rear and the top of the unit

and 5 cm (2 inches) from each side.

● The lens may cloud over when the system is

suddenly moved from cold to warm

surroundings, making it impossible to play a disc.

Leave the system in the warm environment until

the moisture evaporates.

● The mechanical parts of the set contain

self-lubricating bearings and must not be oiled or

lubricated.

● When the system is switched to Standby mode,

it is still consuming some power. To disconnect

the system from the power supply completely,

remove the AC power plug from the wall socket.

● To avoid overheating of the system, a safety

circuit has been built in. Therefore, your system

may switch to Standby mode automatically

under extreme conditions. If this happens, let

the system cool down before reusing it.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Komentarze do niniejszej Instrukcji

Brak uwag

Philips MZ1100 Instrukcja Użytkownika Strona 7

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Radio Philips MZ1100